MegaRail Profile

The MegaRail family of profiles starts with two Illustration of MegaRail 80members:

  • MegaRail 80, shown here, is a large beam with running surfaces for V-groove wheels on all four corners.
  • MegaRail Z, a much smaller profile with a single running surface, is designed to be attached, in pairs, to a flat surface, for a much wider wheel span than is practical with a single profile.

MegaRail 80

The drawing of the MegaRail 80 profile can be found at GitHub. The overall dimensions are 46.4 mm by 87 mm (not including the slightly protruding ribbing). Walls are generally 4 mm thick, although four small sections are 5 mm thick to provide more “bite” for tapping holes. The four screw ports are M6 at 32 mm × 64 mm centers. The running surfaces are wide enough for both RM1 and RM2 steel V-groove bearings (although it’s not a good idea to run steel wheels on it unless it’s hard anodized). The standard MakerSlide V-wheels work, of course. With these, the wheel span is 104.6 mm centers, the same as for OpenRail on Misumi HFS5-4080 profile, or exactly 40 mm wider than for MakerSlide. The parallel running surfaces are centered exactly 40 mm apart.

For extra strength, two MegaRail 80 profiles can be bolted together. The groove pattern on one side nests into that on the opposite side, for perfect alignment.

The profile is extruded out of 6005A aluminium alloy (to be confirmed), and weighs about 3.2 kg per meter (MakerSlide is 0.9 kg per meter).  MegaRail 80 has area moments of inertia (a measure correlated with rigidity) about 18 times larger than MakerSlide in the wider direction, and 25 times in the narrower one. It is about three times more rigid in the wide direction than in the narrow one. I don’t have numbers for torsional rigidity, but I expect an even larger improvement, because of the unbroken outer wall.

MegaRail Z

I have several candidate designs. I’m still pondering which is the best combination of features. MegaRail Z can be used, as the name suggests, as the Z axis of a gantry-style CNC milling machine, but also as the Y axis of a moving-bed machine. There are several different arrangements for the Z axis, each with advantages and disadvantages, and each favours different features (and dimensions) of the profile.

Timeline

No idea yet. I am sending the MegaRail 80 drawing to the extruder/fabricator tomorrow. They will give me an ETA, which I’ll take with a small boulder of salt.

8 thoughts on “MegaRail Profile

  1. Hello

    It may be too late but…

    You should have added one or two sliders inside that would be able to hold PCBs (1.6 mm thickness), so this rail can *also* be used as electronic device housing when cut in short sections (5-10 cm).

Leave a Reply