Status Update

[|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||] MakerSlide quality-checked

[|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||] MakerSlide packed

[|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||] Small parts counted and bagged

[|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||] Bags of small parts picked and packed

[|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||] Items ordered along with the kit picked

[|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||] Complete orders boxed

[|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||] Orders shipped

Progress on eShapeOko kits over the weekend

We’ve made good progress on the eShapeOko kits this past weekend. I quality-checked the MakerSlide for all the remaining kits. We ran out of 500 mm pieces (because so many were damaged), so I cut two dozen of them out of longer pieces. I packed the rail for three-quarters of the remaining kits, and we put about half of them in shipping boxes. We have not yet packed the other items ordered along with the kits (where applicable).

It looks like we will be able to ship all of them this week. They’ll go out in no particular order, because it’s easier for us to pack several kits of the same size at once (but the serial numbers are allocated in the order they were bought, not in the order they’re packed or shipped).

GAUPS 1.0 Arduino-compatible Stepper Motor Driver Shield

GAUPS 1.0 stepper shield PCB (top)For once, something arrives earlier than expected form a supplier!  These lovely things landed today (I wasn’t expecting them until next week at the earliest).  With uncharacteristic swiftness, I made them available in the store.  I even wrote assembly instructions for them!

They’re my own design, so I’m a little excited. Two exclamation marks in a single post! Three, with the last one! OK, now four! Circular reference! (I’ll stop now.)

GAUPS 1.0 stepper shield PCB bottomThe best thing about the board is that, while the component layout is almost the same as that of the buildlog.net stepper shield, it is a new design from the ground up, carefully routed by hand, with an almost uninterrupted ground plane.

I think the DIP switches are a nice touch, too.

Here it is, assembled:

GAUPS 1.0 stepper shield assembled